Using Claude Code to modernize a forgotten Linux kernel driver

Summary

As a bit of background, one of my hobbies is helping people recover data from old tape cartridges, such as QIC-80 tapes, which were a rather popular backup medium in the 1990s among individuals, small businesses, BBS operators, and the like. I have a soft spot for tape media; there’s something about the tactile sensation of holding these tapes in my hands that makes the whole process very joyful, even though QIC tapes are notorious for their many design flaws. With some careful inspection and reconditioning, the data on these tapes is still totally recoverable, even after all these years. Whenever I receive a QIC-80 tape for recovery, I power up one of my older PC workstations which has the appropriate tape drive attached to it, and boot into a very old version of Linux (namely CentOS 3.5), because this is the only way to use the ftape driver, which is the kernel driver necessary for communicating with this tape drive, allowing the user to dump the binary contents of the tape. You see, the drive that reads these tapes connects to the floppy controller on the motherboard. This clever hack was done as a cost-saving measure: instead of having to purchase a separate SCSI adapter (the standard interface for higher-tier tape media), you can just connect this tape drive to your floppy controller, which was already available on most PCs. It can even work alongside your existing floppy drive, on the same ribbon cable! The tradeoff, of course, is that the data rate is limited by the speed of the floppy controller, which was something like 500 Kbps (that’s kilobits, not bytes). The other downside is that the protocol for communicating with these tape drives through the floppy controller was very messy, nonstandard, and not very well-supported. It was a “hack” in every sense: your motherboard’s BIOS had no knowledge of the tape drive being connected, and it was entirely up to the end-user software to know exactly how to manipulate the hardware I/O ports, timings, interrupts, et...